Electrolux · Nepean & Stittsville
Electrolux and Frigidaire speak with a European accent — E-numbers instead of letters. The upside is that the main board reports faults precisely enough to save an hour of guessing, if you know how to read it.
Diagnosis
On site, never over the phone
Warranty
90 days on every repair
Hours
7 days · 7 AM – 11 PM
What we fix
Electrolux and Frigidaire share most of their internals, so if your badge says either one, this is the right page. Send the model number when you book and we will confirm the parts before the visit.
Front loaders on pedestals. Drain pumps, door locks and motor triacs on the main board.
Heating circuits, thermostats and the sensor faults behind a cycle that ends far too early.
Dampers stuck open, evaporator fans, and defrost sensors that drift far enough to ice up a coil.
Built-in models common in newer kitchens. Drain faults, door latches and boards lost after a power cut.
Wall ovens and ranges. Elements, sensors, and locks that stay engaged after a clean cycle.
Induction and glass tops, igniters that will not catch, and control panels that stop responding.
Error codes
The E-code family tells you where to look before anything is opened: E1x is about filling, E2x about draining, E4x about the door, and E5x about the motor. That alone rules out most of the machine.
Every code here needs a technician and a meter.
A code narrows the search — it does not price the job. We confirm the fault with the appliance in front of us before quoting anything.
Service area
Two areas, seven days a week. Electrolux and Frigidaire dishwashers are built into a lot of newer kitchens here, so those parts travel with us as standard.
Recent jobs
Real visits from the last few months. Prices vary by model and by what the diagnosis turns up, but the range is honest.
Barrhaven · EFLS627UTT
The problem
Water left in the drum every few washes, though the filter had been cleaned and looked clear.
What we did
The drain hose sagged behind the pedestal and held water. Re-routed the hose and replaced a worn pump seal.
$185
Parts and labour
Crossing Bridge · FGHB2868TF
The problem
Fresh food side sitting at freezing, produce ruined every few days, no code on the display.
What we did
The damper motor was stuck open. Replaced the damper assembly and checked the sensor reading against a thermometer.
$340
Parts and labour
Amberwood · EI24ID30QS
The problem
No lights, no beep, no response to the door switch after a short outage on the street.
What we did
Main board had failed on the low-voltage side. Replaced the board and ran a full cycle test before leaving.
$395
Parts and labour
About these prices. Each figure covers one specific repair on one specific model, on the day we did it. It is not a price list. What your own appliance costs depends on the fault, the model and the parts it needs, and we can only set that after seeing it — which is why we never quote over the phone.
Book a repair
Leave your details and we'll call back to arrange a visit. Include the model number and the code on the display — nine times out of ten that is enough to load the right part before the technician sets off.
Open 7 days · 7:00 AM – 11:00 PM
In-home service · 90-day warranty on every repair
We price the job after seeing the appliance, and the diagnostic isn't charged when you go ahead with the repair.
Thank You!
Your message has been sent successfully. We'll get back to you shortly.
Your request has been sent. We'll call you back to arrange the visit.
